User`s manual

apfiff09 marine vacon • 151
24-
6
fn
0 %
50 %
Stop
command
Output frequency
DC-Brake
time at
stop
DC-
Brake
Freq.
Figure 7-15. DC-braking time when Stop mode = Ramp
P2.7.1.4 DC braking frequency at stop ID515 -
The output frequency at which the DC braking is applied when making ramping stop.
P2.7.1.5 Scaling of DC-braking current ID400 -
The DC braking current can be reduced with the free analogue input signal between zero
current and the current set with parameter DC Braking Current .
0 = Not used
1 = AI1
2 = AI2
3 = AI3
4 = AI4
5 = FB Limit Scaling ID46 Monitoring value
P2.7.1.6 DC brake current in stop ID1080
Defines the current injected to the motor in stop state when the digital input signal
the DC brake when no run request is active. When
the DC brake is activated the drive will indicate being in Run state.