User`s guide
51
1. Guide
7. System Setup
System Setup
50
1. Guide
7. System Setup
System Setup
[Figure 7-36. Selecting NTP Setup]
[Figure 7-37. NTP Setup]
To receive the international standard time
data from the NTP(Network Time
Protocol) server and to synchronize the
system, select “NTP Setup” and click on
[OK] button.
[Primary Address] and [Secondary Address]
To input the NTP Server address, click on
[Input] button and type in the address of
the NTP server.
[Connection Status]
To check the connection status with the
NTP server in
[Primary Address] or
[Secondary Address] field, click on [Test]
button.
When communication is possible with the
NTP server, “Success” is displayed on the
prograss bar. Otherwise, “Fail” is
displayed.
[NTP Enable]
The operator can decide whether to use
NTP feature or not. To use the NTP
feature, click on [NTP Enable] button.
☞ [Note]
The operator cannot change the time in the Setup menu but can only
set the Time Zone while the NTP feature is enabled.
The NTP server and the system are synchronized every hour.