User`s manual

AMBE-3000™-HDK Development Board
User’s Manual Version 1.1
Connectors, Test Points & IndicatorsSection 2 –
Figure 5 Windows Device Manager
Note Write down the Com Port that is being used for the TUSB3410, this value will be required to run
the HDK control program. In Figure 5 the COM port is shown as COM4.
NOTE: If the TUSB3410 Device is shown with a yellow exclamation point then the USB driver
is not installed. To install it, disconnect the AMBE-3000™ HDK from the PC’s USB port and
re-run the setup.exe program contained in the swrc094.zip file. Then connect the AMBE-
3000™ HDK to the PC’s USB port power it up and allow MS Windows to find new hardware.
When prompted for where the driver to install is located enter the following directory
C:/Program Files/Texas Instruments Inc/TUSB3410 Single Driver Installer/Disk1.
Analog Audio I/O
Page 6
DVSI Confidential Proprietary