User`s manual

Configuration
1. While in Local control mode, select set-up menu from the front
panel and set IP address, Netmask, Gateway and Network.
2. Connect the BitLink Decoder to your network using a standard
RJ-45 Ethernet cable.
3. From the front panel, select menu Utilities > Remote > Web.
Note! It is only possible to use a remote control at the time. Therefore,
while the web interface is used, the front panel (local) control is locked. To
return to front panel control, select menu Utilities > Remote > Local.
Starting
Start Internet Explorer. Type in the IP address (previously set-up from
the front panel) in the address field.
26 • Web Control User's Manual