User`s manual

Set-up menu

Wizard

Input

Output

Utilities

Set-up

Info

Remote mode

IP Addr

Broadcast Addr

Netmask

Gateway Addr

Network Addr

Network Restore

Serial Port

Cancel

Restore

Local

Web

Serial

RS232

RS422

The set-up menu is used to configure the BitLink Decoder for control

via Ethernet and the built-in web control interface.

Remote Mode

Set-up > Remote Mode

Determines how to control the BitLink Decoder; Local (front panel),

Web (web interface via Ethernet connector on the QMC module) or

Serial (RS232 or RS422 on the QMC module).

Note! Only one Remote mode at the time is available. I.e. if Web is

selected, control is not possible from the front panel even if settings can be

viewed.

To obtain protocol information for serial control of the BitLink

Decoder, see Serial Control, page 35.

IP Addr

Set-up > IP Addr

Sets the IP address of the BitLink Decoder.

Default IP address is 192.168.80.200.

22 • Front Panel Control User's Manual