User`s manual

Utilities menu
Wizard
Input
Output
Utilities
Set-up
Info
Boot Other
Load Defaults
SW Upgrade
Clear Alarms
Store Preset
Recall Preset
Cancel
Boot
Cancel
Restore
Cancel
Upgrade
Cancel
Clear Alarms
<Preset no>
<Preset no>
Boot Other
Utilities > Boot Other
Programs another BitLink Decoder via the Ethernet connection on the
QMC module.
Note! Only for factory configuration.
Load Defaults
Utilities > Load Defaults
By using this control, the settings in the BitLink Decoder are restored to
factory defaults.
Factory Defaults
Input Source ASI 1 (Config 2: RF)
Program No. None
Video PID None
PCR PID None
Video Output Format Transparent
SD Monitor 4:3
SD Display Mode Anamorphic
CC EIA608 Field 1+2
CC EIA708 Enable
Audio Embed Enable
Test Pattern Off
Video Ref Stream PCR
ASI 1 Out ASI 1
ASI 2 Out ASI 2
RF Source RF 1
RF Freq 1 362 000 kHz
RF Symbol Rate 14 028 731 baud
20 • Front Panel Control User's Manual