User`s manual

Manual PID
Output > Program > Manual PID
Manual selection of PID.
Video
Output Format
Output > Video > Output Format
This control selects the video format to be displayed. Current selections
available are:
Transparent SD streams are displayed on the SD output. HD
streams are displayed on the HD output.
SD All streams are displayed on the SD output. HD
streams are downconverted to SD.
HD 1080i All streams are displayed on the HD output. SD
streams are upconverted to HD 1080i.
HD 720P All streams are displayed on the HD output. SD
streams are upconverted to HD 720P.
Analogue SDTV
Output > Video > Analogue SDTV
Select whether the analogue SDTV output format should be RGB,
YPbPr or CVBS.
Analogue HDTV
Output > Video > Analogue HDTV
Select whether the analogue HDTV output format should be RGB or
YPbPr.
Note! If YPbPr is selected, the VGA output does not have a valid signal.
Test Pattern
Output > Video > Test Pattern
The BitLink Decoder can output a colour bar test pattern to verify that
video is available. Select SD 480i for a test pattern on the SD output or
HD 1080i or 720P for a test pattern on the HD output. Normally off.
Audio Embed
Output > Video > Audio Embed
Enable to embed audio on the optional SDI outputs.
Auto Embeds the audio, encoded or decoded, according to
the Audio Decode setting.
Off No audio embedding.
Force Bypass Embeds the audio from the stream independent of
Audio Decode setting.
16 • Front Panel Control User's Manual