User`s manual

Brackets attached to BitLink Decoder
WARNING!
Always use two screws per side to secure the brackets.
Connecting
Transport Stream Input
Ensure you have a valid transport stream on either the ASI or the RF
(demodulator) input.
Default (out of the box) setting is ASI 1.
Note! Coaxial cables for ASI inputs and outputs must be double-shielded.
Video Output
Use one of the video outputs and connect to your monitor.
Note! Coaxial cables for SDI outputs must be double-shielded.
Audio Output
Connect the audio output (if available) from the BitLink Decoder to an
audio amplifier or similar.
Default (out of the box) setting is decoded audio, available on both
analogue and digital outputs.
Power
After connecting TS, Video and Audio, power up the unit.
For detailed information on connectors, see Connections, page 37.
User’s Manual Installation • 7