User`s manual

To prevent product overheating, provide proper ventilation and
do not obstruct the ventilation areas on the units.
 Do not operate with suspected failures
If you suspect there is damage to the products, have it
inspected by qualified service personnel. Do not attempt to
repair the failure even if you suspect it may be a minor
problem.
Packaging
Visual check
When you receive the BitLink Decoder, examine the package for
obvious signs of damage. The delivery should not be accepted if the
packaging is damaged.
Open the packaging carefully and check for any obvious product
damage incurred during shipping. If there is any damage please contact
your distributor immediately.
Unpacking
 Check the equipment against the delivery/packing note when
unpacked.
 Retain the packaging, as it is required for warranty shipments.
 Don’t grasp the unit’s front panel when unpacking.
General Installation Instructions
WARNING!
These installation instructions are for use by trained personnel only. To
reduce risk of electric shock, refer servicing to qualified personnel only.
Site Requirements
An ambient temperature should be maintained between 10 deg C (45
deg F) and 40 deg C (104 deg F) at a relative humidity of 10-90% (non-
condensing)
WARNING!
To avoid electric shock, never remove the unit’s lid. There are no user
serviceable parts inside. Refer servicing to qualified personnel. Failure to
comply may result in equipment damage and/or personal injury.
WARNING!
A
lways remove main cord from unit before removing the front panel or the I/O
modules.
4 • Installation User's Manual