User Guide

DS1 User Manual

3. ERROR CODES

Code On screen message Description

0 ERROR Generic error

1 FAN SLOW Fan fault, fan too slow

2 LAMP HOT Lamp too hot (>= 80 C)

3 PSU HOT Dimmer board too hot (IRQ, over 80...85 C)

4 WRONGLAMP Unsupported lamp type, likely a new release

5 CABLE ERR Cable error

6 ACDC ERR AC/DC error

7 1-WIRE ERR 1-Wire error (unable to communicate with lamp unit)

Error codes

Critical/blocking codes; the device attempts to clear these every 30 seconds.

A manual attempt to clear the error can also be made on the DS1 from a single device or

Master (topmost) device in a stack, by pressing OK when the code is on screen. But when

the problem persists the code reappears immediately.