User Guide

26
Factory reset
A factory reset can be performed in order to
change PSU settings to their default values.
This option is located on the bottom of the
SETUP page.
The following parameters will be changed:
• Intensity = 0%, Temperature = 5600K,
Saturation = 0%; Hue = 120 degrees.
• DMX personality is set to DS 16.
• All cached Lamp Unit Calibration Tables
(LUTs) will be cleared. The next boot-up
will be slower due to the need to reload
calibration table for connected Light
module.
• The dimming curve will be set to SQR
(Squared).
This reset will not change:
• The DS MODE setting
• WiFi settings (these are stored in the WiFi
module)
• DMX addresses of light modules (these
are not stored in the PSU)
Main Program (MP) and Bootloader (BL) soft-
ware versions can both be revised from this
page as well.
DS1 User Manual
2. CONTROL / WiFi page