User Guide

24
DS1 User Manual
2. CONTROL / WiFi page
Client mode:
Through the DS DMX app for iOS, it is
possible to connect the DS1 to another DS
Art-Net enabled PSU, or to an existing WiFi
network (a wireless router).
If possible connect the DS1 to a DHCP
enabled router. This ensures that the IP
address, gateway, DNS1 and DNS2 are
automatically assigned to the fixture by the
network. If needed the IP address of the
handle can be altered using DS DMX app.
Client mode example
• WLAN Client
WIFI module is in the “Client” mode. It is
connected to another device or a router.
• Router_X
Name (SSID) of the target network
• DS0162400190172
Hostname of this WIFI module
• 192.168.1.101.
IP address of this WIFI module
“AWAITING WIFI”
This text is displayed when the WiFi module
has not yet finished acquiring its settings.
“CAN’T JOIN” / “WRONG PASS”
This is displayed on the bottom of the WiFi
page when the module is unable to connect
to the assigned Access Point either due to
a name mismatch, the Access Point being
unavailable, or a wrong password. The DS
WiFi module will try to periodically recon-
nect to the appointed Access Point using its
last known settings. If the issue cannot be
rectified, “Reset WiFi” must be performed.