User Guide

14
DS1 User Manual
2. CONTROL / Color page / Color control
Color page
From all menu pages “COLOR” menu will
always be accessible from the bottom of
the screen for quick manual control of the
light modules.
Use the jog-wheel to navigate to “COLOR”
menu and press OK when the page name is
highlighted.
Whenever the PSU is controlled remotely
through DMX or Art-Net, and regardless
of the DMX mode used, the color mix is
always expressed in ITSH values (Intensi-
ty, Temperature, Saturation, Hue) on the
screen of the PSUs COLOR menu.
2.CONTROL
Color control
Turn the jog-wheel slowly for precise con-
trol. The incremental raise of the value is
influenced by the speed of which the but-
ton is turned.
Pressing down on the OK button for 1 sec-
ond while highlighting any ITSH parameter
will cause it to enter preset mode.
Use the jog-wheel to navigate between
presets.
1. Intensity (INT)- expressed in percentag-
es from 0 to 100, it serves as a dimmer.
On the intensity parameter, user tuned
value is always saved as the starting point
for the presets. The presets alternate be-
tween 0%, “user value” and 100%. When no
user preset is defined it will just alter be-
tween 0% and 100%.
Furthermore, holding down the OK button
for two seconds on the intensity parameter
lets you increase or decrease the intensity
by quarter, half or a full light stops.*
The whole dimming range is flicker free on
all DS systems products.
*Intensity is the only parameter with two sets of presets.
2. Temperature (TEMP) – also known as
white balance, is expressed in KELVIN units
(K). It refers to the color temperature of
the light. The lowest setting will give the
warmest light, which is 1500 Kelvin. The
maximum setting is 10,000 Kelvin, which
will give the coldest light.
4
1
2
3