User Guide

12
Attaching Tripod Mounts
The cornerstone of assembling DS1 system
together is the eccentric lock. The DS1 PSU,
Light Module and the Tripod Mounts all have
the same eccentric lock sockets for fixture
building purposes. This allows for great di-
versity for shaping your light fixture to your
needs.
The DS1 system comes with the Light
Module, PSU and Tripod Mount already
assembled to one fixture. This is the standard
setup of the DS1 fixture. But the fixture can
be shaped and assembled any way needed
to.
Here are some key points to keep in mind
when building your fixture.
• We recommend to start the light
fixture assembly with attaching the
tripod Mount to the module.
The tripod mount should be installed on the
correct side of the module in correlation
to the Light Module cable socket. It should
always be on the top left corner when facing
module from the back.
Position the tripod mount to the side of the
Light Module. You can see that an hourglass
shaped opening has been formed from the
eccentric lock sockets. Insert the eccentric
lock halfway to the hourglass shaped socket
and turn the head of the lock clockwise then
tighten it.
DS1 User Manual
1. HARDWARE / Attaching Tripod Mounts
If after installing the light module is able to
move on the tripod mount then the lock must
be tightened some more. Pull the eccentric
lock out halfway twist the lever head clock-
wise and tighten the lock again.
• You can use the whole stem as a junior
pin when the locking nut on the tripod
mount is removed.
• When it comes to Fastening Tripod
Mounts it is easier for the longer end of
the EC Lock to be inserted on the light
head first, then the Tripod mount can
slide on
The cable socket is always
on the top left corner
Lock sockets
Security Washer
Eccentric lock