User Manual
29
6.2 PSU settings
PSU settings enable the conguration of PSU, stack and light module port settings.
6.2.1 Light module operating mode
Row ONLINE enables to switch light module state. Use the Left and Right but-
tons on the keyboard to change the value.
• YES - light module is in a normal working state.
• NO - light module is switched off, the fan is working but no light output.
• BNK - light module starts blinking. This feature is used to identify a light
module visually.
The state is saved on per-port basis, i.e. it does not reset automatically if the
light module is removed from the port and the same or another light module is
connected afterwards.
6.2.2 Channel assignment
Row CH enables the user to assign light modules to
different channels (So entire xture could be controlled
as one uniform light source). By default, all light mod-
ules are in channel 1. Use the Left and Right buttons
on the keyboard to assign a light modules to available
channels (1 through 3). Single stack can be used to
control up to 3 different light xtures.
6 | Light module status and settings menu