User Manual

21
5 | Light control menu
5. Light control menu
To control one or multiple light modules together as one light xture, the system
uses channels. By default, all light modules are assigned to channel 1 (“CH1”).
Light xtures can be controlled with different mixing modes which are:
• WHITE - white balance
• RGBW - Red, Green, Blue and White component control
• COLOR - 360 degree hue wheel
All mixing modes have their individual controls to change different parameters of
light output. It is possible to tune properties like intensity, white balance, and so on.
Use keyboard Left and Right buttons to change
channel or mixing mode. Use keyboard Up and Down
buttons to select different controls on the screen. Yel-
low background indicates selected control (channel
control with CH1 value on the picture.)
When PSU is switched on the rst time, the system
starts in white balance mixing mode and all light
modules are assigned to single xture in channel 1
(“CH1”).
Without any further setup, all the light modules can be
controlled as single xture in white-balance mode by
adjusting intensity, color temperature and tint.
If the PSU is used to drive more than a single xture and is set up appropriately
then new channels will become available in the channel selection (user can as-
sign light modules to CH1, CH2 or CH3). If more than 3 light xtures are desired
then stacks should be re-organized (split) accordingly.
Only channels with assigned lamps are available in light control menus.
Warning! Before switching the PSU on, and while in use,
always make sure no one is blinded by the lights.
!