User Manual
19
3 | Installation instructions
3.6 Connecting light fixtures to PSU
Use the supplied light module cables to connect lightheads to PSU. Use only DS
LED Lighting System cables. Other cables are not supported and can irreversibly
damage the equipment.
Insert one end of the light module cable
into the light module cable connection
socket. Align red dot markings on both
connectors.
To remove the cable, pull outwards from
the plug. Do not pull from the cable.
Some cables may have a locking sys-
tem in place. Release the lock before
pulling out the cable. Do not use exces-
sive force.
Insert the other end of the light module
cable to one of the PSU output ports. Align
red dot markings on both connectors.
To remove the cable, pull outwards from
the plug. Do not pull from the cable.
All light modules connected to a single PSU or stack must be of the same type,
either RGBW (Color) or White only. When light modules of different types are
connected, Master PSU displays an error message and all light modules are
switched off until the problem is rectied.