User Manual

11
3.2 Connecting communication modules
Communication modules allow for the use of various interfaces such as Wi-Fi,
DMX and wireless DMX.
A communication module is mounted to
the accessory port on top of the PSU.
Every communication module has a
guide pin underneath, which should be
aligned with the PSU mounting hole (1).
Keep contact pins (2) clean to ensure
good connection.
The bolt (3) is used to secure the mod-
ule to the PSU.
Turn the power of the PSU off before connecting or remov-
ing the communication module. Failing to do so can render
the module inoperable.
!
3 | Installation instructions
To install the module, rst insert its guide pin into the PSU mounting hole. Hold
the module down against the PSU and fasten the bolt using the supplied 5 mm
hex key. Recommended torque is 4 Nm (3 ft·lb). Do not overtighten.