Specifications

DATA modes. If CW_U gives CW-R on your transceiver, check CW Reverse in the
TRX-Manager's Preferences/Transceiver tab.
JUMA TRX2
TRX-Manager supports the JUMA TRX2 transceiver loaded with the firmware modified by
Adrian 5B4AIY : Version 1.07wb10 or later. You have to configure your Juma with RS232:
JUMA TRX2 and (recommended) Baud Rate:115200. TRX-Manager uses the extended
auto-information mode of this firmware and simultaneous control of the PA100D is still possible
using an Y cable.
TRX-Pan + TRX-Manager works fine with a JUMA TRX2 using the I/Q output of the rig.
However, since TRX2 uses a phasing and I/Q are reversed between LSB and USB, you have to
set up TRX-Pan with: Flip I/Q (not checked), CW:Flip (checked), USB:Flip (checked). You
also have to set up an Offset = Pitch value in CW (in kHz).
With the distribution of TRX-Manager, a stand alone (freeware) application is included:
TRX-Juma. TRX-Juma provides control of the main functions of this transceiver and its
interface mimics the TRX2's front panel. You can not run TRX-Manager and launch
TRX-Juma.exe simultanously, however, the TRX-Juma's interface is also available from
TRX-Manager using the External/TRX-Juma submenu.
TRX-Juma's interface
Page 94