Specifications

OMNI VII
TRX-Manager supports Omni VII in radio mode. Please select OMNIVII in the Setup's combo
box. DTR and RTS must be checked and communication Speed must be set to 57600 bauds.
OmniVII uses hardware handshaking: make sure your cable is wired for RTS Handshaking.
It is recommended you set up the Omni VII's Interface menu item to SERIAL IF and not
Stepp/IR CT (while TRX-Manager supports both).
Almost all main programmable functions including DSP filtering and setting of the levels (AF,
RF,Power, ...) are implemented. Automatic DSP selection must be set from the
Preferences/Transceiver dialog. However, PTT function do not exist in radio mode.
EAGLE, ARGONAUT VI
These transceivers include an USB interface. USB cable is a standard device cable with small
square connector on one end and rectangular USB to computer connector on the other (same
as normally used for a printer.) Do not expect the TenTec optional Model 712 USB Soundcard
Digital Mode Adapter Cable to provide proper connection for rig control and logging : it is used
for digital soundcard applications.The most recent USB driver must be obtained from the
TenTec web site and installed. Please follow instructions provided by TenTec to find the
virtual com port number to be selected from the TRX-Manager's Setup screen.
Communication parameters are 57600 N 8 1. RTS should be checked.
Almost all front panel commands are supported by software (or interface) and are sufficient
for good DXing (see the Programmers reference guide for more information about available
commands: TRX-Manager supports all functions listed).
Note
if a DSP WIDTH command is sent from the program (using the DSP WID slider), the transceiver will
no longer responds to changes using the BW DSP POT on the front panel (until the next power
off/on cycle). Press the DEFAULT button of the levels window to regain control from the DSP
POT. From TRX-Manager, please note DSP slider's range is variable for each mode (AM/SSB/CW).
RX320
Setup
Please select RX320 from Setup and check RTS and DTR. Communication Speed must be set
to 1200 bauds.
Unlike conventional tabletop or portable radio receivers the RX-320 contains no front panel
controls. The receiver hardware relies entirely on an external controller to provide radio-like
functionality. In fact, the receiver is controllable via its DSP : The DSP provides control over
MODE, FREQUENCY, BFO, FILTER, AGC MODE, SPEAKER LEVEL and LINE OUTPUT LEVEL. In
addition, the DSP can respond to requests for SIGNAL STRENGTH (S-Meter).
Current use
DSP
Page 89