Specifications

K3' virtual front panel (KX3 is different)
Colors follow Monitoring's Configuration
As the Elecraft K3 KX3 are still in development, some of the functions may be inactive;
moreover other functions may be added in the future depending on the firmware development.
Some functions require special comments:
(1) (2) Up/Down buttons allows step by step frequency changes and to navigate through the
K3's menus
(3) SUB swich allows you to toggle the VFO Knob from A to B VFO control
(4) This button allows polling the K3 for instant update of the display if it does not update
automatically
(5) The two combos allows you to select a preset DSP bandwidth for Main and Sub receivers.
The SHIFT/WIDTH button toggles to the HI/LO Cut mode. Please note HI/LO Cut mode in
TRX-Manager is only a simulation which uses the only available CAT functions WIDTH and
SHIFT. Consequently difference may appear with the display and behavior of the K3.
(6) This button allows you to center the bandwidth (IF Shift = 0)
(7) MENU and CFG buttons open a list from which you click the desired sub-menu (TECH MD
and RS232 sub-menus are NOT displayed). Items are sorted by alphabetic order. Click OK to
exit the menu mode. Settings up the menu entries are done using UP/DN buttons or dedicated
buttons if available. Warning : not all menu parameters are selectable... This is an issue of the
K3/KX3 protocol, not of the program. This is often the case with sub-menus.
Page 82