Specifications

Mode).

PCT Mode : the DX Spots are displayed under the DX Cluster tab of the Terminal
window.

TNC Mode (Terminal) : the button of the Terminal's toolbar switches the TS-2000
into TNC mode. Please note PKT disables the CAT control until you toggle PKT OFF. PKT
also disables the Terminal port of TRX-Manager.
About PCT Mode
While PCT mode is enabled, the commands of the menu (EX...) do not work: some controls of
TRX-Manager may not work properly while PCT mode is activated (especially the linear amplifier
control command...).
Remote control
Like all other transceivers, your TS-2000/B2000/480/590S/SG may be controlled through a
LAN or the Internet using the standard remote control mode of TRX-Manager, but with limited
functions.
In addition, you may also take full control over your TS-2000/480/590S/SG through a network
using the real remote control mode: TRX-Manager behaves exactly like if the com port is
locally controlled.
Limitations
TRX-Manager does not work exactly the same as the transceiver with Kenwood's ARCP
software. When the sub-receiver has the control or in case of empty memory channels,
TRX-Manager's behavior may be indeterminate and provide unexpected result.
Page 76