Specifications

Reverse CW
This section applies to FT-990/890/900/840/1000D/767GX/757GXII.
These rigs do no feature a CW Reverse function. For these rigs, TRX-Manager makes possible
the reception of CW in LSB mode using split mode. Written for fun, you may find it useful ... or
not!
How to use the CW Reverse function
First, it is necessary set up the correct CW Pitch from the Preferences/Transceiver
dialog (range: 400 - 700 Hz).
Then:
1.
adjust the operating frequency (VFO) for the selected pitch
2.
press Rev (commands panel or monitoring window)
3.
adjust IF Shift (1/4 clockwise) to center the signal (only if a narrow filter is in use)
4.
press Rev again to reestablish normal CW mode.
It is still possible to offset the transmit frequency with the QSX command.
Please don't forget to reset CW-REVERSE before mode or frequency changes because the
transceiver is switched in split mode.
Page 68