Specifications

Possible problems< STRONG>
Shift of the frequency when selecting a CW spot: If you notice a shift of the frequency
(=Pitch/BFO) when you select a Spot after a band+mode change (i.e CW/40m->USB/20m), please
use the CW FREQ DISPLAY transceiver's menu to cancel this shift.
Scanning does not stop: During a scanning (SC command), the firmware does not respond.
Frequencies are not displayed and it is not possible to stop scanning by sending SC0;
Bad communication: Please ensure that RTS (Transceiver and TRX-Manager) are matched. While
RTS=ON (RTS checked) is generally recommended, depending on your hardware, you may have
better results with RTS=OFF (RTS Unchecked).
Preferences
Bandwidth of default filters (Narrow/Wide) must be defined from the
Preferences/Transceiver dialog (DSP frame). Please check DSP/PBT Enabled in order to
activate the automatic filter selection according to mode changes. See also Modes and Filters
.
FILTERS (FTDX9000 FT-2000)
You can not select the bandwidth directly; you have to set up the P2 parameter of the SH
CAT command for each filter from 00 (Narrow) to 31 (Wide). These values may differ from
one rig to another. The CW_W.. SSB_N buttons allows you testing the parameters directly
from the Preferences panel.
P2 parameter (SH Command)
Note: Bandwidths displayed by the program are approximated.
FILTERS (FT-950 FTDX-5000 FTDX3000 FTDX1200)
You select the values directly in Hz from the Preferences panel (CW : bandwidth, SSB :
bandwidth = High-Low). Depending on the supported bandwidths, the program selects the
nearest possible bandwidth and the nearest IF Shift value ; consequently, you may have to
adjust these parameters carefully to suit your requirements.
All values in Hz
How band settings are preserved ?
TRX-Manager preserves all band settings (DSP, IPO, ATT, NB... per band) after a frequency change.
However, the default filter (for the mode) applies if this option is selected (Preferences: DSP/BPT
Page 65