Specifications

Operation with FRG-9600
This section applies for use with the FRG-9600 Receiver.
The FRG-9600 is poorly equipped in CAT commands. The only available CAT commands are the
transfer of a frequency or mode FROM the PC to the FRG-9600. It is thus impossible to read
the status of the receiver (frequencies, modes…) or the S-Meter (at least in a digital way). It
is also not possible to up/download the memory channels.
TRX-Manager was modified to present the most complete possible interface with this receiver
taking into account these characteristics. But attention: if the changes of frequency operated
from TRX-Manager are correctly displayed, any manual modification of the state of the
receiver is not reported.
Monitoring
When opening the monitoring window, the displayed frequency is equal to zero… Select any
valid frequency using the cursor or the keyboard to set the receiver.
Filters and modes
The CW mode does not exist on FRG-9600. The CW selection involves the USB mode. For
the AM and FM modes, it is necessary to fill in the Preferences under Transceiver tab with
regard to the filters really available (select narrow FM preferably).
Channels reports
TRX-Manager implements 99 virtual channels without relationship with the internal channels of
the FRG-9600.
Page 63