Specifications

It is not possible to retrieve from the FT-736/212/412 current operating
conditions. Consequently, you may have a slight difference between transceiver's display and
the PC's display, even when controlling the transceiver from the PC, and of course a big
difference when controlling the transceiver from its front panel!
The FT-212/412 only support setting up of Frequency, CTCSS (Enc, Dec, Tone) and TX/RX
switching. All other commands are not supported.
FT-847
If you own one of the early firmware versions, no monitoring is possible. In this case
TRX-Manager quickly displays NO DUAL when you press the CAT button. You may contact
your Yaesu dealer to upgrade the CPU.
When under CAT control, manual control is still possible. But if the FC-20 antenna tuner is
connected and switched ON, CAT control is not possible.
The optional YF-115C 500Hz filter corresponds to the 250 Hz command.
Saving and loading the configuration (FT-847)
Via the cloning function of the FT-847, it is possible to save the whole configuration of the
transceiver on hard disc and to recall it.
Warning
Leave the CAT mode (CAT OFF ) to carry out this function.
Check the speed for the clone mode : #94 (CLN RATE) so that it is identical at the speed of Setup
of the program ; preferably use a high speed (57600 bauds).
Saving a configuration
1.
open the Transceiver/Save Configurationsubmenu ,
2.
choose a file (.847 as extension), press Save
3.
select the menu #95 of the transceiver (SEND CLN), then press key MCK/W
4.
then press the OK button of the dialog box,
5.
once the transfer on disc carried out, the program confirms the save.
Loading a configuration
1.
open the Transceiver/Load configurationsubmenu ,
2.
choose a file (.847 as extension), press Open,
3.
select the menu #96 of the transceiver (RCV CLN), press key MCK/W,
4.
then press the OK button of the dialog box of the program.
Page 60