Specifications

• With FT-890/900 and FT-100 setting the clarifier is not supported. However, the program
reads the clarifier and displays the right RX frequency. With FT-840, the clarifier (read/write)
is not supported. This could cause the recalled frequency to be wrong.
• With FT-920 and FT-1000MP : SWL and BAND SCOPE are running only with VFO A
selected, real time scanning functions (up down ) are not supported. Some commands of the
Rig's internal electronic keyer are supported (FT-920 : Tools/Rig's Keyer - FT1000MP
Tools/EDSP). With FT-1000MP/MKV selected, scanning from the Monitoring's Up/down
button as well as from the Command panel uses the proper scanning function (smooth tuning).
This may not work properly with older FT-1000MP ; in that case, please unselect AUTO from
the Range dialog of the command panel (receiver will be muted during scanning).
• With arecent Yaesu FT450 to FTDX9000, you must define the width of each DSP filter
under Preferences/Software. See also Modes and Filters.
• With VR-5000, only 4800 bauds speed is supported correctly. Communication is not
bidirectional: reading frequency and mode is not possible. To be under CAT control you must
press the CAT button (located on the main toolbar) or the F9 key. Under CAT control, the
display of the receiver may freeze or the S-Meter may be erratic. S-Meter only runs
properly when the sub-receiver is activated. Consequently, the TRX-Manager's BandScope
only runs with the sub-receiver in AM-N mode by defaut. Reading/writing the internal memory
channels is not possible: memory channels implemented by TRX-Manager are virtual and not
related to the channels of the receiver. VFO A = Main receiver while VFO B = Sub receiver.
The Clone mode is not supported.
Page 51