Specifications

Troubleshooting guide : Serial port

The program doesn't communicate with your rig (or your TNC, Rotor...)

Of course, anything is possible, but please think first that a programming fault is the less likely.

Please read all: almost 99% of the possible situations are covered in this guide and the

TRX-Manager's support page!

Sometime, the synchronization between the transceiver and the display is lost. It is generally

enough to update the synchronization using the Monitoring's Update button. This button has

different layout depending on the transceiver you use : generic , Kenwood , ICOM or

Elecraft .

Otherwise, review all your configuration by opening the My Configuration sub menu. All your

current configuration is displayed and allows you to review all your parameters and settings. You

can save this information into the clipboard by using the copy and paste button.

If the program locks up at startup, you can use TRX-Tools.exe (available from the TRX-Manager's

Start menu) to reset all your settings (TRX1 to TRX4) to DEMO.