Specifications

The Transceiver's preferences are distinct for each Transceiver (Band Plan excepted).
Transceiver model and Logging TX Power are also memorized for each Transceiver.
Preferences are accessible only during the time the corresponding transceiver is selected as
Main Transceiver. If you need a change in the Preferences for a Sub-Transceiver, please
define it temporarily as Main from the Transceiver menu.
Definition: the Operating Transceiver
The Operating transceiver is the one activated for the DX Spots (Web& DX Cluster), the Short
Wave database, the Logbook, the DXCC module, the Quick Memories, CW Interface and the
DX Bar.
By default, at startup, the Main Transceiver is the Operating Transceiver. The Operating
transceiver can be selected at any time and very quickly using the OP button available from
the Monitoring or Sub-Transceiveror Remote control windows (i.e. this OP function provides
logging from a Sub-Transceiver...). The Preferences for the Rotator (by band) follows the
Operating transceiver.
Some modules also provide independent selection of the Operating Transceiver.
In addition, depending on the state of the SO4R option (under Setup/TRX1 tab), OP function
also links the Band Decoder, OLE , Synchronization with the Operating Transceiver.
Selecting the operating transceiver at startup using a command line switch
A switch (/TRX1to /TRX4) can be added to the command line to start TRX-Manager with a specific
main transceiver. The command line must look like this : "C:\Program Files\TRX-Manager.exe"
/TRX2 to start TRX-Manager with TRX2 as main and operating transceiver.
Frequency range
TRX-Manager covers the frequency range from 0.1 to 2000 MHz with the following accuracy:
below 160MHz : 10Hz/1Hz
from 160MHz to 1600MHz : 100Hz/10hz
above 1600MHz : 1KHz/100Hz
Accuracy may be higher with some transceivers.
Page 39