Specifications

The [...] button (just right to the Stop button, during analysis only) opens the Macro button
frame. A right click on a macro button opens the configuration dialog ; please note OFF option
allows configuring a toggle with two commands. If Band/Mode SW Always is NOT checked
(Options), Band/Mod Switch only appears as you press the [...] button ; otherwise it is
always visible below the main frame.
Calibration
If necessary, click CAL (Calibration). TRX-Pan resets MAX/AVG/PAK integration to zero
during Calibration. Click Close to quit Calibration. Note: To use CAL, TRX-Pan should be
actively analysing and should not be in Full Screen mode.
From the Calibration screen, adjust:

Phase and Balance (by using a strong carrier about 10KHz from central frequency) to
minimize Image Frequency's level. A rejection of 50 to 60db can be achieved.

Range and Ref until the spectrum fills in the screen, or to set the maximum and minimum
levels you want to display (in dBm). TRX-Pan remembers these settings for each
band.

Levels to calibrate TRX-Pan for -73dbm=S9. A calibrated generator or simple generator
such as the Elecraft XG-2 is required. In the absence of a generator, you can disconnect
the antenna, tune the transceiver for 10m, and adjust the levels for a noise floor of about
-130dBm to -140dBm with the K3 preamp ON, depending on whether the rig has the buffer
mod and/or whether the LP-PAN has the optional preamp. TRX-Pan remembers this
setting for each value of FFTBins.
Notes

TRXPan automatically ajusts levels according to the state of PREamp and ATTenuator (K3),

Levels interacts with the sound card input levels. If you experience clipping of the spectrum
with strong signals, reduce your sound card level and increase Levels to compensate.

Levels varie according to the number of FFT Bins and sound card resolution. You have to
recalibrate TRX-Pan for each value of FFTBins. However TRX-Pan remembers CAL levels for
the various settings and Range/Ref for each band.
Page 385