Specifications

and RX buttons sets up the Transceiver under the control of TRX-Manager with the
current Frequency and Mode of the second transceiver (only available with Yaesu FT-8X7
ICOM and KENWOOD). From TRX-Manager a Drag and Drop of a frequency to the status
bar sets up the second transceiver with the corresponding frequency and mode:
How to drag the VFO B of a TS-2000 to the VFOA of an IC-703 !
Warning when transmitting: there is no function to protect a transceiver in receive mode.
You must switch it OFF manually.

SteppIR :in this mode, TRX-Synchro controls a SteppIR beam using Kenwood protocol
WITHOUT REGARD as to which transceiver you are using (TenTec, Yaesu...). Speed is
fixed at 4800 bauds and com port is selectable. There is no specific algorithm
(TRX-Synchro follows any frequency change).

Alpha Amp. : : In this mode, TRX-Synchro controls the Alpha amplifier for band changes
and Frequency changes. Speed is fixed at 4800 Bauds and com port is selectable. By using
the Tune Load and ENT buttons, you may store your settings for up to 6 antennas (Ant
1...6).

File : TRX-Synchro behaves like a Kachina transceiver (reads/writes KC505_01.dat).
Page 380