Specifications

TRX-Synchro
A little application TRX-Synchro (also accessible from the Transceiver submenu) is
distributed with TRX-Manager: this program can control a second Transceiver and various
original functions.
Note
This topic is given for reference only. Most of the features supported from TRX-Synchro are now
best supported by the TRX-Manager's synchro function. A notable exception is the Alpha 87A
amplifier.
A TS-2000 controlling an IC-703
TRX-Synchro can also control SteppIR Beams and Alpha 87A Amplifiers.
Conventions

If TRX1 or TRX2 or TRX3 is the main transceiver of TRX-Manager, TRX-Synchro controls
TRX2

If TRX2 is the main transceiver of TRX-Manager, TRX-Synchro controls TRX1

TRX-Synchro follows the Operating transceiver if SO4R is checked.
Using TRX-Synchro and the corresponding Sub-Transceiver is NOT possible since TRX-Synchro
uses the same settings as TRX-Manager. However, in the case of the SteppIR beam or the
Alpha amplifier, serial ports are independent from those of TRX-Manager.
Protocol
Various modes of operation are available by selecting the Protocol:

Synchro : in this mode, the second transceiver follows the transceiver under the control
of TRX-Manager (only available with FT-8X7/890/900/920/990/1000D/M ICOM and
KENWOOD). ICOM and Kenwood follow Split, TX Frequency and PTT (optional).

Dual Receive: in this mode the second transceiver is independently controlled. The TX
Page 379