Specifications

Function buttons
Programmable commands are available to control the TNC by using the Terminal's function
button (1-10, A1-H1, A2-H2). For each button, a right click allows you to program a
function. This feature may be useful to send iterative commands such as sh/u, sh/dx, c
my_dxcluster… Then a simple left click on the button sends the corresponding command.
Check CR to add a carriage return and to send the command
Check CMD to prefix the command with a break signal
Type the text and, if necessary, insert a control code inside brackets { } (Decimal ANSI
value) ; this feature allows you to send special commands to the TNC.
Example

{3} to send a break signal

{13} to send a carriage return (*)

{7} to send a bell
Click OK to validate the command.
(*) the {13} sequence doesn't allow you to send the command. This code may be useful to add a
carriage return inside a text or a succession of commands.
Watch dog

The WD button activates a Watch Dog function (CR sent every 5 minutes).
Page 308