Specifications

The sizeable terminal window shows 4 tabs:

The TNC tab is used to communicate with the controller,

Telnet1 and Telnet2 tabs are used to establish Telnet sessions

The DX Cluster tab displays the DX spots if you are receiving data from a DX Cluster.
You type the text to send in the lower area (TNC Telnet1 Telnet2 tabs). As a default, each
carriage return sends the data inside the two last end of paragraph characters (¶ ) to be
sent.
This module also provides text-data exchange with the Windows clipboard: A right click opens
a contextual menu : copy may be selected in the upper area (received data) and
cut/copy/paste in the lower area (data to send).
Packet
To send a break signal (Ctrl+C or Escape) , you have to press the following tool bar button
. If < Escape> is the command, the terminal displays * to show that you have to enter a
command.
If the DCD line of your controller or TNC is wired, TRX-Manager displays the connection
status in the title bar (and in some cases, the connected station call). If the DCD is not
wired, disconnected will be displayed without any other consequence. Any disconnection
generates the Hand sound system.
Telnet
You have to enter the IP address or the name of the computer into the Host text box under
Telnet1 or Telnet2; then click the go to button in order to establish the connection. (See
Page 301