Specifications

Rotator control
TRX-Manager can control a rotator via a com port or a DDE interface.
Settings
It is possible to define up to two rotators from the Setup dialog box under Rotator (but only
ONE via DDE is supported).
The program is compatible with:

The SARtek-1 universal rotator interface (Azimuth)

Yaesu/Kenpro rotators (Azimuth and Elevation)

Orion PA PX and PX V2.4 (most recent) firmware (Azimuth only)

HyGain rotators (Azimuth)

MicroHAM (Hygain protocol, MicroHAM interface)

KCT interface(Azimuth)

EA4TX's ARSWininterface, Azimuth Elevation(DDE Link) http://www.ea4tx.com

WinRotor (Azimuth) by FUNKBOX http://www.winrotor.com,

RT-21 Green Heron Engineering

Prosistel CD (Azimuth Elevation) www.prosistel.net

N8LP's rotor interface (DDE Link)

YO3DMU's PSTRotator and PstRotatorAz Interface (DDE Link)

AlfaSPID by Alfa Radio http://www.alfaradio.ca
If available, you must specify the serial port used and possibly speed. Other parameters are:

Reverse mounted option : this option applies if your antenna is North centered with the
stops at South : in that case, the program adds 180 degrees to the azimuth,

Offset (0-360°) : support for beams mounted at an offset to minimize coupling with other
beams on the same mast

Settings for the Satellite interface (see below)
Then you still have to assign a rotator to each HAM band from the Preferences dialog box
under Rotator. See also the Band Plan section for the other preferences: Antenna, TX Power,
Tuner, Linear.
Your rotator is not in the list
A software upgrade is possible for any other rotator if you are a registered user of TRX-Manager.
• Particular settings
KCT interface
TRX-Manager launches the MOVENOW.COM program for which you must indicate the path in
the Setup's panel.
DDE Interfaces (ARSWin, PSTRotator, N8LP)
Page 254