Specifications

frequency (LO Frequency) and the Pitch . Some adjustements of LO frequency may be
required to synchronize the programs.
2.
You use a panoramic adapter centered on the transceiver's local IF Frequency (typical
setup for a K3 + LP-Pan): under the Radio tab, please choose SOFTROCK-IF option and
fill in Pitch and Offset with the correct values. Eventually you need to adjust the Offset
parameter under TRX-Manager's Preferences to synchronize frequencies between
TRX-Manager and CW Skimmer (however 0 is OK in most cases). Under the Misc tab,
UNCHECK Decode only in the CW Segment in order to allow CW Decoding for "relative"
frequencies.
Now, from CW Skimmer's Telnet tab, configure CW Skimmer to enable the built-in Telnet
server and to allow Skimmer commands. Please keep 7300 as Telnet port.
CW Skimmer's settings
Setting up TRX-Manager
Few settings are required since you connect CW Skimmer like any DX Cluster server from the
Terminal (Telnet) interface. Just check CW Skimmer under Preferences/Terminal and fill in
the desired Offset (in Hz) between TRX-Manager and CW Skimmer (Offfset can be used to
compensate a shift between CW Skimmer and the real frequency).
TRX-Manager's settings
Page 235