Specifications

CQ Sequencing
TRX-manager includes a sophisticated CQ sequencer.
Principle
The cycle button makes it possible to launch a loop of CQ calls (or any other message).
The delay between calls (CQ Delay) is specified from the Setup under CW (Pause mode is
the default). This is the delay between the beginning of the first CQ and the begenning of the
second CQ (this delay includes the duration of the CQ call).
Operation
Any message can be used for CQ repeating (looping) calls : press first the cycle button
followed by the number of the desired message (M1-M16) or .
This function can be used simultaneously with the automatic switching into TX feature.
Between the calls, the loop stops automatically as soon as you switch into TX manually.
During a call, you must use the STOP button to stop the transmission or the TX interrupt
function (running faster than the Stop button).
Modes Pause and Period
By default, the CQ sequencer uses the Pause mode : it means that the messages are
repeated after the CQ delaydefined from the Setup. However, the extended macros make it
possible to modify the duration of pause for each message or to switch into Period mode : in
this last case the messages are repeated with regular intervals as from the beginning of the
first message (this mode is used for meteor scatter or moonbounce operation, in which
synchronized transmitting and receiving sequences are required).
Page 229