Specifications

2.
Switch into TX directly from the transceiver
3.
Check that the monitoring indicates TX... in the Status box.
If your transceiver does not communicate this data (case of old ICOM transceivers), this
function is usable but there is no checking of the state of the transceiver before the sending
of CW.
Warning
In spite of the apparent simplicity of this function, it invokes a complex logic. It is advised to carry
out many tests before using it with a preamplifier or a linear amplifier. It is essential to switch Off
VOX and BreaK In in order to prevent any undesired starting of a CW transmission. In the same
way, an independent checking circuit is necessary in order to prevent any effect of the failures of
the program, erratic behavior of the communications protocol, or a serial connection which is not
100% reliable.
Page 224