Specifications
Setting up a Linksys Router
Note : this setting does not affect Web activities for other computers of the local network
since it only affects incoming requests, not outgoing data.
It may be necessary to set up your firewall to allow for external requests on the specified
port.
Setting up the server
Port, two cases are possible :
1.
Port 80 checked : the port in use is the port 80 (default port for the Web). This is the
easier way to use the Web Interface but for security reasons, it is recommended you use
another port.
2.
Port 80 unchecked : you type in the port of your choice (i.e 8500) but you must also
specify the base address of the computer; it is a local address for local access only and
the Router’s Internet IP for Internet access (*).
(*) Note : The specified address and port are coded in the head’s Base tag (<BASE ref =…>)
of the html page. If the address is wrong, the interface may display the first time but control
will not be possible. Generally the Internet address of the router works even with local
access.
Password, there are two choices
1.
Password not checked : in that case, control is available to all users at the same time.
There is no logging and (no log of users).
2.
Password checked : you type in the Password (any length) and the maximum period of
inactivity (in minutes) after which the server automatically disconnects. In that case,
only one user can control the radio at the same time. In case of inactivity, the server
disconnects after the specified delay. All users are logged in by IP in the webserver.log
file.
Auto Refresh
If auto refresh is checked please specify the delay (2-30s) after which the page is refreshed.
A refresh is done only once after the most crirical commands. 5s is recommended.
Viewport (iPhone)
Set up for the initial scale of the screen (in Pixels).
Tag
Adds a user defined tag in the <Head> section of the page. I.E:
Page 211