Specifications

Remote control Syntax
You don't need to learn this syntax; the commands are generated by the program
automatically. In case you develop your own interface, the commands available are described
below.
Sending a remote control command
Remote control can be sent :
1.
Using the Terminal (IP: Remote TRX, PKT: Terminal ) and the following syntax : TRXi=CMj;

i is the address of the remote station (Packet i=0-9, IP i=0).

CM is the command as explained below

j is the parameter of the command as explained below

; a delimiter
2.
Using a macro button and the following syntax *CMj where * is a preample and CMj is the
macro command. The delimiter is NOT required. If * is ommitted, the command is
processed as macro command for the transceiver and must follow the protocol of the
transceiver as explained in the macro commands section.
Remote control commands syntax (CMj)
CM = the command
j = the parameter of the command (if available)
The remote controls available are the following ones:
Frequency : FR Frequency in MHz TRX0=FR14.250;
Spot : SOmffffffff|CALLDX|COMMENT m=MODE (=0-6/A=AUTO) ffffffff=RX
Freq(in MHz) SOA14.200|F6DEX|TRX-MANAGER
TX Frequency: FTmffffffff m=MODE (=0-6,A=AUTO) ffffffff=TX Freq in MHz
(FR-14.205 Default mode, FTX= 14.205)
UP : UP 1 (CW) or UP5 (SSB) + Split mode
Mode : MD Mode (0-6) TRX0=MD2;
Int. Scan : TS 0=Up 1=Down 2=Stop
Filter : FL Filter (0-4) TRX0=FL3;
Page 200