Specifications

When an alarm happens, please press OK to turn off alarm and re-activate the transmitter or
the amplifier.
If Auto is NOT activated, only Cross-band conditions will be displayed as an alarm. However,
in that case TRX-Manager does not perform any action on the relay or the transmitter.
When a Cross-Band alarm prompts, you can turn off Split to turn off the Alarm (or OPR
if cross-band is needed).
Tune F. and Tune >provides a quick, timed tuning using full or reduced output power
(according to your Options).
Digital Wattmeters
If a digital wattmeter LP-100 or LP-100A or ALPHAPOWER (4500) or Elecraft W2 is connected
on your computer (to set up from SETUP/TRX1 tab), the linear reminder displays direct power
(FWD) and SWR during the transmission. Maximal "wattage" during the last transmission stays
displayed during RX.
Linear Reminder & LP-100
LP-100
w W T buttons allows fast changes of the measurement mode (see LP-100's manual). It is
possible to scroll Alarm Set Pointvalues by double clicking the displayed value (<nnn).
Depending of your Options for PTT SWR!, an SWR alarm stops the transmission (ONLY if you
key down TX via CAT) and switches to STANDBY (see OPR/SBY function). However, please
note the LP-100's PTT loop is ALWAYS faster than your computer.
ALPHA, W2
At startup, Alarm set point is fixed to 3.0. It is possible to scroll Alarm Set Pointvalues by
double clicking the displayed value (<nnn). Depending of your Options for PTT SWR! a n SWR
alarm stops the transmission (ONLY if you key down TX via CAT) and switches to STANDBY
(see OPR/SBY function). RESET resets Autorange to 5W.
Page 175