Specifications

Linear-Reminder - Operation
Even if you don't own an automatic - CAT controlled - linear amplifier, this little module can be
very useful to help you using your manual amplifier (or your manual antenna tuner). The Linear
Reminder provides the following functions:

Alarm for band changes and cross-mode

Display of preset values for Tune Load + 2 user defined fields (USR1 USR2 ) for about
260 segments between 1.8MHz to 55MHz

Tune function : full power, reduced power, temporization

Automatic Linear relay control (or state of transmitter) by Segments or Drive power

Support for Telepost Inc. LP-100 & LP-100A ALPHAPOWER (4500) ELECRAFT W2 Digital
Wattmeters

Gain calculation and Assisted Tune (for Experts).
The Linear-Reminder only supports the Main transceiver; however, all options are memorized
for each transceiver (TRX1..4).
The linear reminder does NOT support a Remote and OLE wattmeters.
The Linear-Reminder module opens from the Tools/Linear-Reminder submenu .
Warning
This module provides a timed Tune function. But in case you encounter RFI (Radio Frequency
Interference) on your computer, it can lock up while your transceiver is keying. Consequently,
please always watch your transceiver's status and make sure you can stop keying manually in all
situations.
Functions

AUTO : Set ON/OFF Alarm and automatic Relay Control after Band-Segment changes
(Cross-Band Alarm remains ON whatever the state of Auto but OPR/SBY control is not
activated if Auto is OFF)

OPR: State (OPR/SBY) of Linear Amplifier or Transmitter (see below and Options )

Tune F. : Full Power Tune (power by default, see Options )

Tune > : Reduced Power Tune (as set up from the Power slider)

OK : Tuned (OK Button) = > set OFF Alarm

: Options and Settings
Page 173