Specifications

Macro dialog appears after a right click on a macro buttons
Selecting a predefined function
If you select a function, please make sure the function is available and supported by your
transceiver. Displayed functions may be (*) :
NB: Noise Blanker
NR: Noise Reduction
PRE: Preamplifier
ATT: Attenuator
ANF: Automatic Notch Filter
COM: Speech processor
RXA: RX Antenna
BC : Beat Cancel (TS-2000/480)
VOX : Vox
A=B : A=B
A/B : A/B
SPL : Split
UP1 : QSX up 1 KHz
SUB : Opens/Close Sub Receiver (or dual watch)
VFO: Set Frequency, mode...
QSX: Set QSX Operation
INF: Set current Spot (Info)
LOG : Quick Log (of current Spot) and Save
M>V : Current Channel to VFO
V>M : VFO to current Channel
PWB : restore default power for the current band
(Preferences).
SPO : CWT+Tune (K3), Kenwoods(CW Tune)
(*) The list is variable from one rig to another.
Writing a CAT Command
Please type the CAT command in the corresponding text box. If Off is checked, the macro
will be an On/Off button and two CAT commands are required. If Off is NOT checked, it will
be a command button and only one CAT command is required.
The Caption field allows you to display a short name for the function. The Test button (if
available) allows you testing the function immediatly.
Depending on the type of transceiver (ICOM or Kenwood/Yaesu), the Syntax is very different.
You have to use the correct syntax by referring to the Transceiver's manual (see also CAT
Programming).
Page 145