Specifications

Band scope parameters
Mode (Auto by default)
The software scans in CW mode. This is because, in this mode, generally AGC delay is
switched to FAST by the rig. You may select manual to scan with the current mode and filter
selected but with a loss of precision. Otherwise, the mode determines which mode is selected
when the scan pauses: if Auto is selected the program switches to the mode defined by the
band plan.
Accuracy
In Auto mode the accuracy of analysis may be defined from 1 (low) to 8 (high). This
parameter has an influence on the analysis delay. In TFS mode and higher precision (8), it
takes some hours to fill in all the screen but only a few minutes with the lower precision (1
).
In Manual mode, you must set up the scanning Step (in KHz).
Center frequency
Any frequency allowed by your transceiver.
Sometime, you may wish to define the lower and upper end of the spectrum (to avoid a
mental arithmetic): click the button to display the corresponding text boxes.
Width
Half width of spectrum in KHz by step of 50 kHz.
Page 130