Specifications

Band scope overview
The band scope function gives a pleasant view of the band activity and provides graphic
tuning of your transceiver.
TRX-Manager needs to scan the desired band portion to display the spectrum. This scanning
may be controlled by the signal strength to pause on busy frequencies.
To open the band scope, you need to activate the Tools/Band Scope (Ctrl-B) submenu or
the corresponding tools bar button .
Note
This bandscope it NOT a real time one and does not replace a panadapter!
Buttons
Below are the functions of each button:
: (or Enter) to start or to restart analysis
: (or Escape) to stop scanning
: to re-draw the spectrum if altered.
: to initialize parameters (center frequency and spectrum width) from current transceiver
frequency or any HAM band
: This button toggles from FS analysis to TFS analysis (Frequency Time Signal).
Graphic tuning
When the scanning is ended and the spectrum displayed, you only need to click a desired
portion on spectrum to tune your transceiver to the corresponding frequency.
Analysis mode
The band scope provides a classical representation of the spectrum (FS for Frequency,
Signal) but also an analysis for a long period of time ( TFS for Time, Frequency, Signal or
Waterfall) : each value of the signal is translated into a colour (Blue=S0 Green=S9
Page 128