Specifications

Editing the memory channels
Direct editing of memory channels is very easy from the Edit/Memory Window. Most of
supported parameters may be edited.
You edit the parameters and click Apply to save.
You move to another channel by clicking up/down buttons or click OK to exit the
window.
It is also possible to quickly fill the contents of the memories by drag and drop. The icon
(frequency) can be dropped into the channel's display of the Monitoring window or directly
into the list of the channels - in this case, with each addition of a frequency, the current
channel number is incremented.
Notes

Offset may be converted into a Shift between the RX and the TX frequencies (especially on
ICOM and Kenwood). See also Repeater settings.

When editing a channel, auto-mode should be disabled (OFF) ; otherwise, when checking on
the memory channel by switching the transceiver, the Monitoring may reset the mode to its
default value (according to the band plan).

This function does not apply to all Transceivers
Page 121