Specifications

Scanning dialog
From the Scanning dialog, you may define:

the Lower and Upper scanning limits (MHz)

the Center frequency (MHz) and the scanning Range (KHz)...

a comment for the scanning range (caption)

by checking Scan from/to: enable the scanning range (or disable it for a continuous
scanning)

scanning memories by clicking M then the memory number (1-10)

recall a particular scanning frequency & range by clicking the corresponding memory
number

a particular step or setting up the program to calculate it according to the mode and the
frequency in use by clicking Auto.

the behavior of the Tuning by digits function (see above)
By clicking Scan, scanning starts immediatly from the Center frequency. If you click OK,
Scanning range will be effective only if the current frequency is within the scanning range.
Clicking the Tuning knob stops scanning.
Notes
If you own a FT-990/890/840/900/1000D/980/767GX the best choice for slow scanning is AUTO.
That option allows you to have the benefit of the Internal scanning function of the transceiver. The
scanning step is the one defined by the transceiver. With these Yaesu transceivers, the Auto mode
(Internal scanning) prevents the receiver from being chopped off during scanning,
If you own a FT-1000MP, you can try to configure the program for FT-1000MP MKV in order to have
the benefit of the internal scanning function (according to the versions of your ROM, this command
may be supported or give unexpected behaviors),
In the other cases, if Auto is checked, the program calculates a variable step according to the
mode, etc... If AUTO is not checked, step stays constant and the one defined from the Scanning
dialog.
Page 114