Owner`s manual

For 4-ch operation set channels 45-48 (DM1000), 53-56 (02R96) or 93-96 (DM2000);

or for 8 channel operation channels 41-48 (DM1000) 49-56 (02R96) or 89-56 (DM2000) as

follows:

Insert: On/Off: ON; Out: NONE; In: NONE; Position: POST-FADER.

EQ: OFF

DELAY: ON, msec: 0.5; samples: 24; Mix: +100%; FB Gain: 0%.

Set bus 1-4 or 1-8 delay to: ON; msec: 0.2; Samples: 8

IMPORTANT: These channels, with the output routing, create a monitor matrix for feeding

signals from the edit recorder or a Previewed Machine to the external monitoring system.

Therefore, to avoid feedback, these last 4 or 8 channels should not be routed to the Program

buses.

Open Setup page: MIDI/Host and remove any assignments already made.

Set To Host (if present): Serial#

Set Rx port: Serial 1

Set Tx port Serial 1

Open MIDI page: Setup

Deselect all current settings.

Make the following settings:

Receive Channel: 1

Transmit Channel 1

Activate: Rx Parameter Change

Activate: Tx Parameter Change

Set Fader Resolution: Low

Apply appropriate routing of all input channels associated with video sources controlled by

the Edit Controller or Vision Switcher. For testing, route each group of four channels to buses

1 to 4 on a 1:1 basis – channel 1 of group bus 1, ch2 to bus etc.

The BVE02 checks for input channel routing to buses 1-8 and whether the corresponding track on the

Recorder is in Edit mode before it controls the channel fader. Input channels not routed to a bus are

therefore not controlled by the BVE02.

Once the mixer is configured, test all input channels, buses, outputs and monitoring/metering

paths for continuity and correct signal level.

Connect BVE02 Mixer port to DM1000, 02R96 or DM2000 serial port with cables made up

using the specifications provided in the Connections section of this manual.

Open Automix: Main page display. Activate ENABLED .

This ENABLED switch enables and disables the control of the mixer from the BVE02. This state

is reported to the connected edit controller or Vision Switcher which will report the mixer

status as OFFLINE or DISABLED

To avoid conflicts with the on-board dynamic mix automation, it is recommended that there is no

connection to the Timecode Input port on the rear of the mixer.

Store the resulting mixer configuration in a mixer memory and write-protect it against

inadvertent update.

If the mixer or suite is to be used for a number of different tasks, it is strongly recommended

that a different setup is prepared for each application and stored in a separate write-

protected mixer memory.