Owner`s manual

11
Edit Controller Setups
The setup of the Edit Controller varies according to the type of editor. An example of the
setup is shown below. This information may also be helpful as a guide to those Edit
Controllers which are not shown below.
Sony BVE9100
The setup for the audio mixer control is described in the BVE9100 manual section “2-7-3
Setting the Mixer Control Conditions (MIXER LOCAL)” As a simple guide the recommended
setup is:-
1. Enter the setup - press the MIXER LOCAL (SHIFT + LOCAL SWER) key.
2. Press F3 (ENABLE) to set MIXER LOCAL REMOTE CONTROL =ENABLE.
3. Press F7 (CTRL MODE) to move to the mixer control mode page.
4. Press F1 (PVW MODE) to move to the preview mode page.
5. Press F6 (PVW/MON) to set PREVIEW MODE=PVW/MON (PARA).
6. Press the ENTER key to store the change and return to the mixer control mode
page.
7. Press F2 (MON SEL) to move to the monitor mode page.
8. Press F8 to select second page of options.
9. Press F1 (LINE-PVW to set MONITOR SELECT =LINE-PVW(MIX).
10. Press the ENTER key to store the change and return to the mixer control mode
page.
11. Press the ENTER key to return to the mixer remote control mode page.
12. Press the ENTER key to exit the setup page and return to the main edit data page.
The Machine configuration page on the BVE9100 should be used to set the audio mixer
Machine number for each VTR. This number will specify the group of mixer input channels
that carry the audio signals from each VTR. The Machine number for the various input group
combinations available is listed in the ‘Machine Assignments’ section of this manual. The
BVE9100 has separate configuration entries for the MIXR and MON audio Machine numbers
of each VTR. Both entries should be set to the same number.
Depending upon the hardware and software version of the BVE9100, you may have to make
the following settings:
1. From the Main Page, select INIT.
2. Press F3 - ASSIGN.
3. Set value for “Switcher” to show SW/MON/MX.
4. Press RET to Accept and return to Main Page.
5. Hold SHIFT and Press MULTI-EDL to enter SETUP.
6. Press F3 – IDC.
7. Select Port “SW/MON/MX” using cursor keys.
8. Press F8 - ENTRY.
9. Press F6 - SERIAL IF MIXER.
10. Change DATA-3 to Set Byte 2 to 1 (4Channel).
11. Change DATA-3 to Set Byte 1 to 1 (Machine).
12. Press RETURN sufficient times to return to Main Page.
The Serial Mixer settings for the IDC should also be set to support serial control using Machine
selection. These setting should be as detailed for a GPS type audio mixer in the Sony manual.