User Manual

Digital Security Controls Ltd. 30 Private and Confidential
Installation Manual DATE : 09/30/97 DRAFT
411 Callback request made REMOTE - CALLBACK REQUESTED (restore not applicable)
412 Successful Download access REMOTE - SUCCESSFUL ACCESS (restore not applicable)
413 Unsuccessful access REMOTE - UNSUCCESSFUL ACCESS (restore not applicable)
414 System Shutdown REMOTE - SYSTEM SHUTDOWN
415 Dialer Shutdown REMOTE - DIALER SHUTDOWN
Access Control
421 Access denied ACCESS - ACCESS DENIED - USER #
422 Access report by user ACCESS - ACCESS GAINED - USER #
System Disables
5AA-51A
Sounder / Relay Disables
52A Sounder / Relay disable DISABLE - SOUNDER / RELAY #
521 Bell 1 disable DISABLE - BELL / SIREN 1
522 Bell 2 disable DISABLE - BELL / SIREN 2
523 Alarm relay disable DISABLE - ALARM RELAY
524 Trouble relay disable DISABLE - TROUBLE RELAY
525 Reversing relay disable DISABLE - REVERSING RELAY
System Peripheral Disables
53A-54A
Communication Disables
551 Dialer disabled DISABLE - DIALER DISABLE
552 Radio xmitter disabled DISABLE - RADIO DISABLE
Bypasses
57A Zone bypass BYPASS - ZONE BYPASS - #
571 Fire bypass BYPASS - FIRE BYPASS - #
572 24 Hour zone bypass BYPASS - 24 HOUR BYPASS - #
573 Burg bypass BYPASS - BURG. BYPASS - #
574 Group bypass BYPASS - GROUP BYPASS
Test / Misc.
6A1 Manual Trigger TestTEST - MANUALLY TRIGGERED (restore not applicable)
6A2 Periodic Test report TEST - PERIODIC (restore not applicable)
6A3 Periodic RF xmission TEST - PERIODIC RADIO (restore not applicable)
6A4 Fire test TEST - FIRE TEST (restore not applicable)
6A5 Status report to follow TEST - STATUS FOLLOWS (restore not applicable)
6A6 Listen-in to follow TEST - LISTEN-IN ACTIVE (restore not applicable)
6A7 Walk test mode TEST - WALK TEST MODE
Pager
Pager format uses SurGard 4/3 DTMF timing parameters.
It sends the Account Code, reporting code and a [#] (Hex “C”) 1 time only.
There is no checksum, parity or handshake.
This communication format cannot be used for Backup or Alternate dialing (Phone Number 3).
Communication of this format shall not generate or clear any FTC conditions.
Note: If an Automatic Communications format is used for any other phone number, the desired reporting code to be
transmitted via Pager must be programmed for the event!
8.2.12 Communicator Call Directions [361]-[368]
For events from each Call Direction group the control panel can call 2 different phone numbers and use the LINKS as backup
or as a redundant communicator for one or both numbers. The Third phone number can only be used as a backup or
alternate of the first.
Each report falls under one of the following 5 Groups:
System Alarms & Restorals
System Openings & Closings
System Tampers & Restorals
System Maintenance Alarms & Restorals
System Test Transmissions
Each group can be assigned to the following Call Directions
Option 1 1st Telephone Number (and 3rd Telephone Number if enabled for Alternate or Backup)
Option 2 2nd Telephone Number